Ah, thanks then, Phil. The starts are a bit dodgey at the best of times.
For those like me who don't use Prib and/or wish to position their pitguy & board at the place I suggested above, you may alter your 'track65.ini' file by:
1. Save a copy for backup in another location or rename it, 'track65_org.ini' or some such name.
2. Open the service file and cut this portion, "pit_board = -16.6 13939.6 -100.0 100.0" from the line: "pit_board = 10.0 1200.0 -100.0 100.0 ; dlat of board, dlong of board, dlong LOS start, dlong LOS end (last 2 not used)".
3. Add a line below the pit board datum and paste in the bit you just cut, "pit_board = 10.0 1200.0 -100.0 100.0".
4. In front of this new line, place a semi-colon, ";" to render the line as a comment only. You do this only to have the original data readily available to swap back in if needs be and to serve as reference for any subsequent position alterations.
5. In the original line for the pitboard, install the following: "pit_board = 10.0 1200.0 -100.0 100.0". You can do a simple copy/paste from this very line to avoid an error. No quotes, of course.
6. Your full pitboard line should now read, "pit_board = 10.0 1200.0 -100.0 100.0 ; dlat of board, dlong of board, dlong LOS start, dlong LOS end (last 2 not used)".
7. Save the file.
Test before the race. You should find the pitguy on the left side of the road just shy of the right-hand bend leading up to Les Combes. Give him a wave as you roar by. Speeds are not so great there that there's plenty of time to read the information.
Good Luck!
Doni
PS: Let the buyer beware!